Baracoda USB Plug User Manual download pdf (Page 11)

Baracoda USB Plug & Scan User Guide

6.2

Unpair the scanner

Chapter 4 of this user guide explains how to unpair the scanner from the USB P&P dongle.

Please note that the USB P&P forces the settings of the scanner to which it gets connected in the

following configuration:

• Restore scan engine defaults

• Enable default code ID

• Set Slave Mode

• Automatic reconnection: NO

• Set output format: Baracoda Frame, enable acknowledgment, no prefix/suffix (and, only for the

BaracodaPencil, enable barcodes buffering)

• Number of beeps for “Good scan”: 0

• Number of beeps for “Ack”: 1

It may be problematic if you use the same scanner in the above configuration with an application that does

not give an acknowledgment back to the scanner.

Be aware that if you need the scanner to go back to its standard mode you have to use the RESET

barcode (see chapter 4)

6.3

Print version

Gives the firmware version of the USB Plug & Scan.

<: ? >v \ NUL \ NUL

rintVersion

7 Compatibility

The USB Plug & Scan is only compatible with the following Baracoda barcode readers:

• BC/BL/BLR2604 (minimum Bluetooth version required: 1.6 and minimum Decoder version required

BT085)

• BCM 2604-L and BCM2604-F (All)

• BaracodaPencil (minimum Bluetooth version required 1.5 and minimum Decoder version required 1.5)

• Roadrunners (BRR-L and BRR-F)

1 2 ... 6 7 8 9 10 11

No comments

Baracoda USB Plug User Manual Page 11